Alpha Tool.Com.HK Limited VSP-230 Instrukcja Użytkownika Pobierz pdf (Strona 15)

SPEED POT FEEDBACK SENSOR

This polisher is equipped with a Closed Loop Feedback sensor that is attached to the

speed pot. When a load is applied to the tool, the sensor will re-adjust the RPM to

maintain a constant speed.

WATER CONTROL VALVE

CAUTION!

Adjust the water ﬂ ow to wet the stone and remove waste, excessive spray and mist will get

inside the tool and cause premature failure of the tool and/or cause the GFCI to trip.

This polisher is equipped with a center water-feed system. Water ﬂ ow to the spindle

shower bolt can be controlled by throttling the valve stem as seen in Figure 8, Figure 9

and Figure 10.

Water Valve in

closed position

Water Valve in

half open position

Water Valve in full open position

Figure-8

Figure-9

Figure-10

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Brak uwag

Alpha Tool.Com.HK Limited VSP-230 Instrukcja Użytkownika Strona 15